STE
| State Event detection | |
| Inputs(1) | i |
| Parameters(2) | p1 p2 |
| Default | p1=1e-3, p2=0, |
| Select from | Components/Blocks/All |
| Function | State Event detection on i. Interpolation of the zero-crossing until abs(i) < p1 p2 < 0 : Zero-crossing detection only for crossings from - to + p2 > 0 : Zero-crossing detection only for crossings from + to - p2=0 : Zero-crossing detection for both crossings. |
| Special | Only state event detection on the zero-crossings caused in the block diagram model can be performed. If the state event occurs because of a zero crossing in the circuit, the state event can not be interpolated. A voltage or current zero crossing in the circuit can be detected, if the input of the STE block is a VOLTAGE or CURRENT block straight. The CURRENT block is allowed to measure a current through a voltage source, diode or resistor, but not through an inductor or capacitor. |