SawTooth - Saw

preview

Connection Diagram:

     SAW
    

Connections(1)PositionRemark
SAW Right Saw waveform output

Parameters(5)DefaultRemark
d(0..1) 1 Duty Cycle ( 0 .. 1 ) Set to 1 for for a full sawtooth
DC_offset 0 DC Offset
Phase(0-360) 0 Phase in degrees ( 0 .. 360 )
Frequency 1kHz Frequency in Hz
Amplitude 1 Amplitude

Function Saw waveform
Special The duty cycle specifies the percentage of the rising and signal.
Note Set d=1 for a full saw tooth

Status Standard

Select from Components\Library\Control\Sources

See also
Decrease, ProgrammableSource, ProgrammableSourceInterpolated, Pulse, PulseWidth, saw, SAW2, Signal2Current3Phase, Signal2Voltage3Phase, sin, SIN3phase, SIN3phaseAngularPostition, square, square2, SquareWave, SquareWave3phase, step, Timer, TRAP, TRAP_DC, triangle, Triangle2, TriangleWave, Vector2Voltage,
© 2024 CASPOC, All rights reserved. Home   |   Terms and Conditions   |   Legal   |   Export Compliance   |   Privacy Policy   |   Site Map