HallSinglePhase - Hall Sensor Single Phase
Connection Diagram:
| SHAFT |
| HALL |
| Connections(2) | Position | Remark |
| SHAFT | Left | Rotor shaft, connect to the drive |
| HALL | Right | Hall signal output |
| Parameters(5) | Default | Remark |
| PolePairs[.] | 2 | Number of pole pairs[.] |
| PhaseAdvance[Rad] | 1.5 | PhaseAdvance of the Hall Sensor[Rad] |
| Amplitude | 1 | Amplitude of the Hall signal |
| AngularMagnetWidth[Rad] | 2.5 | Angular magnet width specifies the length of the on time of the Hall sensor depending on the angular position of the shaft |
| AngularFluxChangeWidth[Rad] | 0.64 | Angular flux changing width specifies the length of the flux changing of the Hall sensor depending on the angular position of the shaft |
| Function | Single Phase Hall Sensor output signal, +/-1 | |
| Special | The angular magnet pole width specifies the width of the magnet in Radians. The slope width specifies the angular width where the flux changes from north to south direction. Specify this value in Radians | |
| Note | The total width (magnet+flux change) should be smaller than PI. | |
| Status | Standard | |
| Select from | Components\Library\ElectricalMachines\Brushlesscontrol | |
See also
BipolarPWM, CommutationSequence120, HallThreePhase, pwm, PWMBip2, UnipolarPWM,