HallSinglePhase - Hall Sensor Single Phase

preview

Connection Diagram:

SHAFT HALL
    

Connections(2)PositionRemark
SHAFT Left Rotor shaft, connect to the drive
HALL Right Hall signal output

Parameters(5)DefaultRemark
PolePairs[.] 2 Number of pole pairs[.]
PhaseAdvance[Rad] 1.5 PhaseAdvance of the Hall Sensor[Rad]
Amplitude 1 Amplitude of the Hall signal
AngularMagnetWidth[Rad] 2.5 Angular magnet width specifies the length of the on time of the Hall sensor depending on the angular position of the shaft
AngularFluxChangeWidth[Rad] 0.64 Angular flux changing width specifies the length of the flux changing of the Hall sensor depending on the angular position of the shaft

Function Single Phase Hall Sensor output signal, +/-1
Special The angular magnet pole width specifies the width of the magnet in Radians. The slope width specifies the angular width where the flux changes from north to south direction. Specify this value in Radians
Note The total width (magnet+flux change) should be smaller than PI.

Status Standard

Select from Components\Library\Sensor\Rotational\Encoder

See also
DCTacho, DiscretePosition, esi, HallThreePhase, IncrementalEncoder, PositionSpeedTorque, ResolverSinus, ResolverTrapezoidal, Tacho,
© 2024 CASPOC, All rights reserved. Home   |   Terms and Conditions   |   Legal   |   Export Compliance   |   Privacy Policy   |   Site Map