FallingEdge - Falling Edge Generator


Connection Diagram:


SAW Right Saw waveform output

d(0..1) 1 Duty Cycle ( 0 .. 1 ) Set to 1 for for a full sawtooth
DC_offset 0.5 DC Offset
Phase(0-360) 0 Phase in degrees ( 0 .. 360 )
Frequency 1kHz Frequency in Hz
Amplitude 0.5 Amplitude

Function Function Generator for PWM
Special The duty cycle specifies the percentage of the rising and signal.
Note Set d=1 for a full saw tooth

Status Standard

Select from Components\Library\AdvancedElectricalDrives\Source\Scalar

See also
Carrier, CarrierMod, Constant, ConstantAngularElectricalSpeed, ConstantAngularShaftSpeed, Down, Pi, Reference, RisingEdge, sin, SquareWave, Step, Up, UpDown, V_F_Control,
© 2018 CASPOC, All rights reserved. Home   |   Terms and Conditions   |   Legal   |   Export Compliance   |   Privacy Policy   |   Site Map